Recent content by Austringer

I was trying to get the torque a little close.

I was told there was a modification that could be done to a civ tool that was on the site but after running multiple searches, nothing has come up.

Looking for a wheel nut socket to remove the lock nuts on the axle spindle on the goat. Is there a civ version?

Do you have the drawings for the engine stand, lift bar and chain length? I need to pull the pack from my former Navy (Kings Bay Ga) Dragoon 300 APC. Want to clean it up and it has a busted hydraulic hose. It runs.

Does anyone have a manual (prefer in PDF) for these new gen and the both model regulators listed above?

one I just put in and the system still does not charge... FML

The "NOS" one that popped. Thinking about swapping out board of fried one (if I can find a way to test it first) or swapping out the burned componets with the ones from the fried one as they still seem to be good (need to test)

The older generator and regulator that was on the vehicle.

Trying to get the 200amp system on one of my vehicles to charge as it basically never charged since I have had the vehicle. It had the following 200 amp generator on it (non-NSN stamped on it - Picture 1) and a 2920-01-300-3737 200 amp regulator on it by prestolite. The regulator was...

AWESOME! Been looking for this a while. Much appreciated!

Thanks but that is the cross drive manual for the M113A3, I need the transmission parts manual for the M113A2. The manual posted is 9-2520-272-34P not the 9-2520-254-34P, thanks for the post though.

Trying to find a PDF version but no luck. Jason

Have a 1993 M998, everything seemed to run fine until I noticed an issue about a week ago after apparently the vehicle was left in the "run" position overnight. Went out the following morning and found 1) both batteries seemed to be dead. (1 week old correct military batteries (Aug 23...

Last i heard, 10 plus years ago was that it was being built up as a bug out vehicle. I need to reach out to him and see if he finished it.

If you want a 1 or 2 man turret, reach out to OSMWI in Carrolton GA. Gerald has one or two nice turrets that could work, just not sure of the exact ring diameter.