Recent content by Csm Davis

I have a set and was thinking about the same thing for my M936A2. I believe that they will work just fine but may be a little wiggly on road

Thanks Dave!

The new pump has a bigger piston and moves more fuel per stroke good for easier priming and keeps the engine from leaning out from lack of fuel. Cummins did a service bulletin but not a recall for the 5.9 and it should have covered the 8.3 also. Just make sure the pump you get that the primer...

The military uses 12v batteries also hooked like you have here. Just hook that wire to the positive terminal of the battery that it's directly over and that's 12v. Your fan switch for the heater if you have one gets 12v for the low speed.

This thread sux without pictures! Have many M936 bits and pieces laying around might could spare a piece here and there to help out a young man such as yourself.

Yes you can. Minor rubbing may occur according to wheel selection.

@AH64-longbow Peter, Long read for just a few questions. If you are a welder and a helicopter pilot, you are more than qualified to fix all of the short comings of this truck. 1st remove the washer or slice it off and or move the roller arm for the air switch to where they no longer meet and...

@74M35A2

One wrecker is never even close to enough if you plan on using it. I broke 4 in five days once and wasn't being stupid on 3 of those it just happens on equipment that has so many systems and moving parts. It also lets you work one while working on and waiting for parts for the other one. And...

New diesel primer/ transfer pump on the M936A2 of course it kept me out of the veterans day parade. 😔

I prefer slime or a liquid tire sealer helps balance and prevent water getting in the belts of the tire.

The military actually made a mount like this, I believe I have one.

Okay so this might help now and in the future. When setting up your 936 wreckers, engage your pto and give it enough throttle to have the transmission go through all the gears up to 5th then set the rpms to 1500. Failure to do so can cause transmission damage.

Would like to get the valves maybe complete boat. Can't believe idiot cut them like that. You can get glue and repair kits from Zodiac, not sure it would fix that though.

Well I now have a military boat and no forum to show it off on! Zodiac FC470 combat rubber raiding craft, picture for help.