Recent content by dodgemain

I got mine at Boyce Equipment & Parts Co.

Hi, I went ahead and installed the aftermarket fuel shutoff. It fits and functions fine. The fuel line has a bubble flare instead of a 37 or 45 degree flare. Here is a picture of it installed.

Thanks, Dave. But, I had already bought an aftermarket one.

Hi, Anyone using an Aftermarket Fuel Shutoff Valve on their M809 Series truck? It does not look like a direct replacement. Are they anygood? Thanks

Hi, The voltage is under 30 at the headlights. Will have to check it again to get the actual readings. I have went through 3 sets of headlights (they were the correct bulbs) trying to fix this issue. I need tips on how to troubleshoot the real problem. Because obviously what I have been doing is...

Hi, The headlights on my M1165A1 have not worked since I've owned it. They burnout within minutes if I attempt to use them. I have installed a grounding harness and think I checked all the grounds. Also tried a different light switch, voltage regulator, and controller. All the voltage readings...

Hi, Have a M1165A1 with a 400 amp Niehoff alternator. Been trying to fix a bouncing volt gauge needle. My question is about taking readings with a multimeter at the voltage regulator and battery's. Should the readings be pretty steady? Currently the readings fluctuate around +/- 1 or 2 volts. Thanks

In

Hi, Finally had time have someone come out and hook a computer to my truck. Ended up being 3 bad injectors. Had all 6 replaced and it running great now. Thanks

Thanks for everyone's help and comments. I now have the information I was looking for.

Thanks for your smartass response to my post. I have already looked in the manual and it only lists a cable assembly. Unless I am missing it somewhere.

Hi Again, Thanks for all help. But, I was hoping to find the parts number for the Cannon Plug so I can make my own wiring harness. Thanks again.

Hi, Does anyone know the part number for the plug that bolts to the dash for the winch controller? Or, if anyone has a spare wiring harness they want to sell let me know. Thanks

I have been busy with work. Hoping I will have time this weekend to work on the truck. Will have an update for you next week. Thanks for the help.

I am looking for some help with my M916A3 I purchased over the summer. It has a 60 Series Detroit diesel engine that is hard to start and idles rough. If I can get it to start it runs very rough at below 500 RPM. After sometime the RPM will climb by itself to alittle of 500 RPMs. The engine...