Recent content by Evil Dr. Porkchop

Usually there’s a small plate on the right side of the frame but it’s just the responsible agency. B1 data plates were probably a hard to find item so they get changed out for a regular m416 plate if needed. I think the b1 I use to own had “b1” hand stamped on the plate afterwards. Yes the...

The can holders and smaller diameter lifting hoops would indicate it's an m416b1. The data plate is definitely a replacement, and it's on typical m416/m151 steel wheels instead of the mighty mite wheels.

Bump

Still available

Bump

Bump

Bump

Here’s a few pics of some in service.

Here’s a 1984 I had a couple years back. We bought it at auction after seeing one terrible pic of it. It had been used as a storage shed and hadn’t run in probably 20+ years, but being off the road kept the body and frame in nice shape for a northeast vehicle. We changed the fluids and...

I have a couple oa-331 engines with direct drive spicer 3052 transmissionsand radiators still attached. Both fired off, and were removed from parts trucks. Radiators were holding fluid. Edit: One engine is sold, the one pictured is still available. $800 each. Pick up in Colchester, VT I...

Selling a set of 3 (missing 1, you need 4 total for a full install) Lightweight Weapons Station mounting legs. As seen there are the brackets for the front legs attached. For m923 and similar 5 tons. $100, pick up only in Colchester, VT. I’m not able to ship them.

Bump, still have holley carbs.

I have two of these available. This panel goes behind the seats to reinforce the cab for the m66 gun setup. Fits m35 series, as well as m39 and m809 series 5 tons. $100 each, must pick up in Colchester, VT

Selling a T-case PTO for m939 series 5 ton trucks. Should fit all models, as long as your application has clearance behind the t case for it. Note that you will need the collar that goes on the t case shaft, which is not included. $400 Located in Colchester VT, can ship.

All zenith carbs are sold. I have a few holleys still available.