Recent content by Plasa

Thank you for your kind words! It's always hard to identify problems from distance. I try to do my best... Christian

I found only the classical detroit locker, but not the selectables. Do you know where they are availlable? Christian

And the detroit locker a pain in the ass... Christian

Thank you very much! I have to check it if they have a hex wrench. from outside it looks not. what a mess... in the tm seems that the tee is attached directly to the valve, but no one knows if the tm is correct Christian

Hello forum. I'm in the middle of nowhere and I have a little annoying problem. The cab level sensor behind the cab is leaking air. If I move the tube that come from the tanks it's changing, so I think it's a problem of the fitting between sensor and tube. I already tried to cut the tube, put...

I did not put it on the display because with 20chars and 2 lines there is not many options to display. On the display zou already see: - status of the wet tank - status of the 3 valves - pressure preset in psi - actual pressure when in use in psi - some error codes like wheel valves not closing...

And about debugging: There's a reason why in the controller is a usb cable. If you connect the arduino to a PC with the arduino ide open, you see all the telemetrics of the system, like status of wet tank, settings, pressures, valve status etc. So debugging is possible, without any special...

Hello to all. Actually I'm not really on facebook anymore... I agree that it's almost a prototype that now works for 5 years. I have still the first version of the controller and works. If someone have a problem with one of my controller please write me a PM here, or even better, a email...

Thank you @Ronmar! You're the best! Christian

Just a stupid question. If it's a matter of spacing, why not keep the original bearing and add a washer to get the 8.5mm space? And the spacer can be of alluminium or plastic, easy to make and the bearing is always under load. Christian

Anyone knows a source where to find the new composite washer? It's not available on finditparts or elsewhere...

Do you have a transmission that is affected by the Allison letter to change the bearing if transmission is before a certain serial number?

Hello forum. Does anyone knows the tech specs of the hydraulic motor of the winch, or a type plate? Mine is leaking and needs to be replaced... Thank you! Christian

I think it's ATF oil because it's red. Does anyone already change the seals of the pto? What components have to be remove to unmount the pto gear box? For sure air filter, but also coolant reservoir?

Thank you for the input. I clean it up and for me seems to come from the pto between pto and hyd. pump. But I am not sure because the oil is not clear but red. (atf3?). Is there any hose ore other stuff from the trans over the pto? I can live if it's hyd. oil or from the pto shaft. but having a...