Search results

This forum is dedicated to excerpts from the manuals since they require a diagnostic computer with manuals loaded already to access (PM me). If there is any specific MTVR technical info you need I can upload it here. MTVR Spindle Replacement MTVR Fuel Efficient Modification MTVR CTIS...

Attached are the manuals for the MRZR. I will try to upload the service manuals soon but they are larger and not wanting to upload.

Here are the following instructions needed to do a hub seal replacement on an MTVR as well as hub bearings.

Here is the procedure to do a pressure test on an MTVR and LVSR.

How to remove and install the planetary hat on MTVR

Instructions for the replacement of the fluid inside the wheel hubs.

Sooooo. It's not that easy, or cheap, or fast. Some info: Stock case: 1.27:1 Reduction 1810 Input yoke 1710 rear output yoke 1610 front output yoke 55000: 1.00:1.00 High The yokes will vary. If you do not match the specs of the stock case you will need to change some things. This conversion...

Does anyone have or willing to send me the dimensions for each armored panel and chicken shield for the MCTAGS copula?

Hi all. New to the generator world but getting a HDT Drash trailer tomorrow so might as well start. I am big into diagnostic stuff for MVs and just got my hands on some generator specific software if you guys are interested in kits to service your truck and generators let me know. These take a...

All the air circuit diagrams for specifically the MK23 WTEC 3 W/O AC.

All of the Pneumatic Diagrams for a MK23 WTEC 3 W/O AC

Has anyone done any research on a m939 rear shock absorber upgrade? I saw some of the prototype m939 trucks have them at approximately a 45 degree angle on the front axle. Think it would help my constant hopping on my rear axle.

Anyone interested in a dual circuit ctis system? This means the front and rear tire pressures are able to be programmed independently to have better tire wear and ride quality. Some of the factory black ctis controllers are able to use this system or the newer MRAP controllers with the...

(DEAD PROJECT) Are you looking to purchase MTVR doors for your MTVR? As you may know, Oshkosh is currently asking over $26,000 for a pair of doors and the price is only increasing every few months. We have finalized the design of new replacement doors and am looking to determine the number of...

What are the differences between a m939 and LMTV CTIS controller. Are they interchangeable and if not why?

Does anyone have the part number or an eBay listing for the 3 solenoids on the pneumatic control unit under the passenger side kickplate? Not talking about the pressure transducer.

Does anyone know how much gear oil a M925 winch will take on both sides of the gearbox?

A little confusing here but I assume it is the same. I have an m931a2 with dual g177s and I want to convert it back to super singles. I want to know what all I would need. Do I need to change out the studs or just get new nuts?

Is it possible using LMTV wheels and tires on a m931a2 and use the LMTV CTIS wheel valves and such on a 5 ton and still have it work?

I tore apart the front of the intermediate axle on my m923a0 to replace the front seal on the axle. In the process of getting the front cover off I tore and bent the shims on the top loader. Is there any specifics on lash and other precise measurements to take the rest of it apart and replace...