Search results

I have two tested fine.

I have solenoids...checked good.

Only have this stuff.

I might have all that stuff.

Front and rear Milemarker brackets a different....and rear winch does not have a solenoid attached.

The shop i listed earlier in Abilene tx......tested 6 for me.

The turret itself , less the plate and tubes is M10xx series Hmmwv parts. Lots of mods needed to use as is in the normal turret location. Or add it behind the 2 man top from B pillar to D pillar...4 legs and lots a mods.

Those brackets are on few Hmmwv's and on Mraps...Heavy antenna use. They are stainless steel.

M&D diesel Abilene tx.

Check to see if lift pump on right front lower engine....has been replaced...if so, they might have put it on wrong missing the push rod.

In all Hmmwv parts manuals, the flexplate is a 14077157 for 6.2, 6.5NA, and 6.5 turbo. NSN 2815-01-148-3771

If the truck is a true m1123 it will have the 2 check valves by the tank unless someone already removed them.... The check valve up at the filter is ok to leave in...its a weak one and should not fail closed.

The 2 check valves down by the tank should be removed....the larger hose one is feed line and it usally causes the no fuel issue. Put in two longer hoses and be done with that.

If you have the money and not the time to build your own start box out of used and cheap china parts...then a Camo box would be the answer. All new quality parts...not china parts, new style box to fit trucks that also have that internal armor part.

I have a few of those actuators without valves I tested last week....4 of 5 of them checked out good. $40 ea.

Don't make those anymore.

I might have one available....12342807 or 12480732

Early 90's...some people got hmmwv bodys and put them on Chevy suburban / truck frames.

M1152 I have has diodes at injection pump area, inside dash at heater motor wires, at horn, and might be more. Info on PS mag issue 744...search : TB 43-PS-744

Must be. One of mine is available.