Recent content by rbeeson

Pick Pick-up tube had a pin hole in the top, got the hole brazed up and that took care of her. Runs smooth as silk.

Good afternoon, first I would like to thank you for your help. It was a fueling issues and I got it fixed today. I took supply line from tank and ran it to a fuel can, and it ran great pulled pick tube out and found pin hole brazed up and that took care of her she runs like a swing machine...

it seems to be the same load or unloaded. I wondered about air in the fuel, I'll check those lines today.

Heres a video link to watch it running.

I did I can push up on linkage and increase engine speed

Here you go.

Okay so I know its been a while since i have posted new information about my running issue. I had shoulder surgery and was unable to work on it. So, I check with my TM book and made sure governor seems to be set right which I believe it to be. Crazy thing is it runs fine till warm then...

Thanks for the information.

Will do.

I'll give a check as well. Just got to pull the sounds encloser off to check.

It has always started right up since I I'll give that a check and report back. Thank you sir have had it.

Doesn't seem to matter what the outside temperature is, she runs smooth till it gets some heat built up. Has 59 hours on the meter, all fuel filters and complete engine service just done will all filters changed. I believe the governor is set about midways down I'll have to recheck it. This...

Thanks for the information on the starter deal, I'll check it out. I'll try and upload a clip of it running and try to link it.

I am new to the military generators; I recently purchased a mep-003a it's a 1986 model it runs great pulls good power, but when it warms up its act like its stubbles some only when warm. When it does it you can see the governor arm move not sure if the governor is causing the issue or if its...

Yes, I knew it was an old thread just taking a stab in the dark.