Search results

Always best to start lower if in doubt. Use a 10amp. I would be surprised it draws more than that.

Depends on the fan but I suspect 10amp or 15amp will work. Fan should state what it draws?

So for perspective, The USMC "newer" models that are coming out have not yet been released by the other branches, so I would think there is a lot in the pipeline still to come even with the ones diverted to Ukraine. YMMV.

It is dimensional pricing and will knock your socks off due to measurements not weight. I was selling them here in New Orleans and UPS tried to bill me a stupid surcharge for oversize after the fact on my last shipment. I won the fight but it was an ordeal.

Try radio nerds https://www.radionerds.com/

Not sure if this is a tractor but known issue that the brake shoes sieze/rust to the drum and require bfh to drums....

That wrench extender is very interesting. I googled it and found it in Amazon. Might need to add to my overextended ( my wife's opinion ;-) ) holdings of hand tools.

Brass is "relatively" easier to remove than going back with steel or stainless if there is another problem down the road. A little heat, some penetrating oil, and a left hand twist extractor should make it a painless operation.... Teflon tape or preferably the liquid /paste sealer not only does...

High beam through floor dimmer switch

A master cylinder can leak internally and leak out of the rear. Check all hard lines especially if exposed to salt or deicing fluid plus rubber lines and wheel cylinders. Parking brake has its own warning light circuit when engaged. the low fluid warning circuit has a sensor on the...

I just thought it was sloppy casting clean up from the block. I had not seen that in a civy vehicle.

That answers the question with the regulator it is probably 200. Some older models had 100 but that is not as common as the 200. The 400 would power the space shuttle and weighs 17 tons...Lol Damn shame as the 200 is a small fortune. With a new key weight and pulley with a lock washer under the...

What flavor of Alt 60amp , 100, 200 or 400? I assume v belts so likely 60 or 200. Were all the mounting bolts and brace snug? Brackets?

On the m939, the heater core is a great place for funk to accumulate if not flushed out regularly. First time, I flushed it, I was amazed how much "mud" came out.

load test your batteries individually when fully charged 12.4-12.6 I suspect one or both are not up to spec. I am ole and old school and use one of these to load test charged batteries...

Just wanted to make sure you know they use different brackets.

That USMC gmv probably went swimming on a beach...

Did you jump start it or slave it using the port? My swag is the batteries we're too low and should have been charged first. An arrant spark or surge fried the box most likely and let out the magic smoke.

i officially Jealous of your ride! :clinto: Nice score. The hood rack and fist grips are a small fortune plus all the other goodies :tank:

Narton makes a new model of the pushbutton that has a deeper face and fits the hmmwv dash better. I have that on my hmmwv with no issues. Also have the other style on my m923. Both require a supplemental ground wire.